NEO FreeRunner Bike Holder. OpenSCAD model + STL ready for printing

the holder is equipped with a recess for an additional LiPo battery, a power conversion module DC-DC Boost to 5v, a charging module and a LED light.

The holder is split into 2 halves and fastened with two bolts (3x50mm)

Parametric settings

Switching between the halves

CUT=1
CUT=0

To switch off the split into parts

HALFCUT=false

To change the tilt (15 degrees by default)

angle = 15

License

Copyright © 2021 Dmitry Shalnov [interplaymedium.org]

Licensed under the Apache License, Version 2.0 (the "License"); you may not use this files except in compliance with the License. You may obtain a copy of the License at

http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.